7 Steps for Fresh Sealant Application

Procedure for Facade Leakage Removal and Application of Fresh Sealant

Facade Maintenance

Fresh Sealant Application

Here is the procedure we followed while working on a Project for Larsen and Toubro:

1. Visual Inspection: Grooves between Glass panels, at edges of glass panels, and between ACP panels will have sealant. We installed the Cradle (by following Safety norms and after having a Third-Party Audit) for Visual Inspection.

Facade Maintenance-Worn out sealant
The groove where Fresh Weather Sealant is to be filled

2. Removing Existing Sealant: One should remove the Complete sealant filled in grooves since there will be no bonding between the existing dry sealant and fresh sealant which will be wet. 

Facade Maintenance-Removal of Worn out sealant
Removing dry sealant from Grooves with Knife

3. Complete removal of sealant by Wire Brush: Complete removal of existing dry weather sealant is only possible if you remove a small residual of sealant for the surface, we used a wire brush for the same.

Facade Maintenance- Removal of Worn out sealant by Wire Brush
Removing Dry Sealant by Wire Brush

4a. Cleaning: Remove the debris accumulated at the surface.

Facade Maintenance-Cleaning surface
Removing debris from grooves and surface

4b. Cleaning: Have a clean piece of cotton and Liquid soap mixed with water on it.

Facade Maintenance-applying Soap for cleaning
Using Soap Liquid and Cloth

4c. Cleaning: Clean the surface properly and allow it to dry.

Facade Maintenance-Surface Cleaning
Cleaning the surface

5. Placing the masking tape:  Place the masking tape exactly at the edges on both sides of the groove. The width of the masking tape should be more than 1 inch ( 25.4mm).

Facade Maintenance-applying masking Tape
Applying Masking tape at the edge of the panel

 6. Filling the Weather Sealant:  Fill the sealant gun with the Weather sealant. Ensure the nozzle is clean at the tip. Else very leas amount of sealant comes out and it takes a longer time to fill the groove.

Facade Maintenance-Applying Fresh sealant
Applying Weather sealant by Silicon Gun

7. Completion:  Level the sealant filled in a groove to the surface of the glass / ACP panel/ outer surface. Ensure the entire groove is filled sufficiently. Remove the masking tape gently.


-Pankaj Ghare.
Director,
Landscape Wall Systems
9819 663 630

Post a Comment

0 Comments